Delta AH500 Manual page 507

Ch a pt er 11 DeviceNet Re m ote I/O Module AHRTU-DNET
Click "COM1 Setting" on the left side to enter the interface where set the communication parameters
of COM1 and select the special register parameters to be mapped to the device (COM1 is set to
Modbus mode and its communication format should be consistent with those of slave 28SV and
VFD connected to COM1 and thus the baud rate is set to 38400 bps).
Click "COM2 Setting" on the left side to enter the interface where set the communication parameters
of COM2 and select the special register parameters to be mapped to the device. (COM2 is set to UD
Link mode and its communication format should be consistent with that of slave connected to
COM2.)
11-81