Delta AH500 Manual page 397

9. Select "Network" >> "Scanner Setting" and "Scanner Setting" dialog box pops up. After picking
"Slave Mode", fill the appropriate data length and mapping address of the slave. Click "OK" after
setting is over.
Note: "Output Size" and "Input Size" under "Polled" in the above window are used for setting the
data length of AH10DNET-5A as the slave.
10. Select "Network" >> "Download" and then the following dialog box appears, where click "OK" to
download the configuration data to AH10DNET-5A automatically.
Note: If "E7" is displayed on AH10DNET-5A, please remove its DeviceNet terminals before
downloading. Otherwise, failure to download will occur.
11. Power off the AH500 series CPU module and then power it on again after downloading is
finished. And at the time, AH10DNET-5A is set to the slave mode.
Method 2: Setting slave mode and the starting addresses of the mapping areas through
DeviceNet Builder
Note: Compared to the first method, the second one is a bit simpler but D device is probably used by
multiple modules at the same time because of no uniform configuration through HWCONFIG.
Please think carefully before adopting this method.
1. PC accesses an AH500 series CPU module via USB after connecting the device according to
the following figure.
Ch a pt er 1 0 De v ic eN e t Com m unic at i on Mo d ul e A H 10 DN ET
1 0 - 3 5