Delta AH500 Manual page 702

AH500 Module Manual
23. Click "Address Table" on the left-side window to set the offset addresses of master.
For details, please refer to "Mapping relationships between master PLC and slave PLC" in the
following section.
For the IW or QW-type module, try to adjust the offset address to start at 0 or an even number
for the purpose of easy control via the program.
User could tick "2 Byte boundaries" to adjust the offset address or not pick "Auto addressing" in
the following figure and directly input the offset address value in "Address" column.
Click "Process Data" on the left-side window and the details about the slave configuration pop
out on the right-side window. The corresponding relationships between the configured modules
of the slave and the modules in the Input list and the Output list in the above figure are shown in
the following window.
14-72