Delta AH500 Manual page 341

#611
#612 ~ #627 W
#628 ~ #643
#645 #644 W
#647 #646 W
#649 #648 W
#650 W
#651 W
#653 #652 W
#654 W
#655 W
#657 #656 W
#658 W
#659 W
#665 ~ #660
#666 W
#667
#668 R
#669 R
#671 #670
#672 ~ #684 R/W
#697 ~ #685 R/W
#710 ~ #698 R/W
#723 ~ #711 R/W
Ch ap te r 9 Ether ne t Co mmun ica tio n Mo du le AH1 0 /1 5 EN
Reserved
Sending commands to the
connection 1~16
Reserved
Command information object
address (IOA)
Command value
Command SV
Data point number of the
slave station
Data point type identification
of the slave station
Data point Information object
address (IOA) of the slave
station
Data point group mask of the
slave station
Data point flags of the slave
station
Data point value of the slave
station
Data point of the slave station
for data mapping
Data point of the slave station
for data mapping
Reserved
Setting up the database of the
slave station
Reserved
Counter register for the data
point of the slave station
The status of remote device
Reserved
CPU register number
corresponding to the master
connection 1
CPU register number
corresponding to the master
connection 2
CPU register number
corresponding to the master
connection 3
CPU register number
One word represents one
connection of a remote device.
Input a command code to send the
command and work with
CR#644~CR#649 to write the
parameters in.
Information object address (IOA) of
the connection to be written with a
command
The value of the connection to be
written with a command
The 2 nd value of the connection to
be written with a command
(according to the requirement of
the data type; if there's no
requirement, leave it blank.)
Data point number of the data type
to be created
The data point type to be created
The IOA of the to be created data
point
The mask of the to be created data
point
The flags of the to be created data
point
The default value of the to be
created data point
The corresponding register number
(D or M) of the PLC to the data
point to be created
1: enable the settings of the data
point for one time; after it is done,
resets it to 0.
0: reset this setting
1: enable the settings of the
database; after it is done, reset it to
0.
The number of the already used
data point
The number of connected master
devices
One word represents one data
type; the written code is the
corresponding register number of
the data type
9 - 11