Delta AH500 Manual page 671

6. Pick "Overwrite slave specific Watchdog Control Time" and then click "Adjust" button to
make an automatic adjustment of the bus parameters.
(For the meaning of each item, please refer to the user manual of AH10PFBM-5A.)
7. Click "Address Table" on the left-side window to set the offset addresses of master.
For details, please refer to "Mapping relationships between master PLC and slave PLC" in
the following section.
If the offset address of the IW or QW-type module is not even, it should be adjusted to start
at the even number for the purpose of easy control via the program.
We suggest user tick "2 Byte boundaries" to adjust the offset address or not pick "Auto
addressing" in the following figure and directly input the offset address value in "Address"
column.
Chapter 14 Remote I/O Communication Module AHRTU-PFBS
14-41