Ethernet Oam Configuration Settings - D-Link xStack DGS-3620 Series Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
Parameter
Unit
From Port / To Port
Mode
State
Remote Loopback
Received Remote
Loopback
Click the Apply button to accept the changes made for each individual section.

Ethernet OAM Configuration Settings

This window is used to configure Ethernet OAM configuration settings.
To view this window, click OAM > Ethernet OAM > Ethernet OAM Configuration Settings, as shown below:
Description
Select the switch unit to configure.
Select a range of ports you wish to configure.
Use the drop-down menu to select to operate in either Active or Passive. The default
mode is Active.
Use the drop-down menu to enable or disable the OAM function.
Use the drop-down menu to select Ethernet OAM remote loopback.
None – Select to disable the remote loopback.
Start – Select to request the peer to change to the remote loopback mode.
Stop - Select to request the peer to change to the normal operation mode.
Use the drop-down menu to configure the client to process or to ignore the received
Ethernet OAM remote loopback command.
Process – Select to process the received Ethernet OAM remote loopback command.
Ignore - Select to ignore the received Ethernet OAM remote loopback command.
550