Section 2: Setup And Installation Procedures; Choosing A Good Location; About Moisture Condensation; Unpacking And Inspection - HID DTC1000M User Manual

© 2012 HID Global Corporation

Section 2: Setup and Installation Procedures

This section describes the setup and installation for the DTC1000, DTC1000M, and the DTC4000
Card Printers.

Choosing a Good Location

Follow these guidelines:

Place the unit in a location with adequate air circulation to prevent internal heat build up.

Use the Printer's dimensions as a guideline for the minimum clearances to the unit. (Note: Allow for
adequate clearance in front of the unit to accommodate the unit with its Covers open.)

Do not install unit near heat sources such as radiators or air ducts or in a place subject to direct
sunlight, excessive dust, mechanical vibration or shock.

About Moisture Condensation

If the unit is brought directly from a cold to a warm location or is placed in a very damp room, moisture
may condense inside the unit. Should this occur, print quality may not be optimum.
Leave the unit unplugged in a warm, dry room for several hours before using. This will allow the moisture
to evaporate.
Caution: For safety purposes, Ethernet is not intended for a direct connection outside of the
building.

Unpacking and Inspection

While unpacking your Printer, inspect the carton to ensure that no damage has occurred during shipping.
Make sure that all supplied accessories are included with your unit.
Check that the following items are included:

Power Supply

US / EU Power Cable

USB cable (2.0)

Software Installation CD

Card Printer User Guide

Warranty Statement, Compliancy Document
DTC1000/DTC1000M/DTC4000 Card Printer/Encoder User Guide (L001398, Revision 1.5)
All rights reserved
17