Table of Contents
Advertisement
About Moisture Condensation
If the unit is brought directly from a cold to a warm location or is placed in a very damp room,
moisture may condense inside the unit. Should this occur, print quality may not be optimum.
Leave the unit turned OFF in a warm, dry room for several hours before using. This will allow
the moisture to evaporate.
Caution: For safety purposes, Ethernet is not intended for a direct connection
outside of the building.
Module Installation Procedures
Installing the Output Module Accessory
Parts included: Output Module Accessory Kit, Torx tool and screws
Tools needed: Torx Tool (included in kit)
Estimated Repair Time: 20 minutes
Step
Procedure
1
Caution: Power off the Printer by unplugging the power cord from
the Printer.
2
Remove all USB, Serial, and Ethernet communication connections. Remove
the Card Output Hopper.
Important: Do not remove the Covers for this procedure.
3
The Output Module is installed at the output side of the Printer.
4
a. Turn the Printer and the Output Module on their back.
b. Use the Torx tool provided to remove the two (2) screws from the bottom
of the Output Module. Save the screws for later for reattachment.
5
If the Printer Module has the Output Side Upgrade Cover installed, then
follow the Removing the Output Side Upgrade Cover (if applicable)
procedure (provided below these instructions).
6
Position the Output Module attachment tabs into the appropriate slots at the
base of Printer. See Display A (below).
7
Use the two (2) screws to attach the Output Module to the Printer. Please
refer to the pictures below.
HDPii High Definition Card Printer/Encoder User Guide
L001130 Rev 1.4
38
Advertisement
Table of Contents
Troubleshooting
