Setup And Installation Procedures; Selecting A Good Location; About Moisture Condensation - HID Fargo DTC5500LMX User Manual

Setup and Installation Procedures

This section describes the setup and installation for the DTC5500LMX Card Printer.
2.1

Selecting a Good Location

The following guidelines help to ensure optimal printing performance:
Place the unit in a location with adequate air circulation to prevent internal heat buildup.

Use the printer's dimensions as a guideline for the minimum clearances to the unit.

Note: Allow for adequate clearance in front of the unit to accommodate the unit with its covers
open.
Do not install unit near heat sources such as radiators or air ducts or in a place subject to direct

sunlight, excessive dust, mechanical vibration or shock.
2.1.1

About Moisture Condensation

If the unit is brought directly from a cold to a warm location or is placed in a very damp room,
moisture may condense inside the unit. Should this occur, print quality may not be optimal.
Leave the unit unplugged in a warm, dry room for several hours before using to evaporate any
moisture.
Caution: For safety purposes, Ethernet is not intended for a direct connection outside of
the building.
Attention: Pour des raisons de sécurité, Ethernet n'est pas conçu pour une connexion
directe à l'extérieur du bâtiment.
November 2015
Chapter
PLT-02496, Version: 1.0
2