Section 2: Setup And Installation; Selecting A Good Location; Moisture Condensation - HID FARGO HDP 6600 X002200 User Manual

2 Setup and installation
This section describes the setup and installation for the HDP®6600 card printer.

2.1 Selecting a good location

The following guidelines help to ensure optimal printing performance:
Place the unit in a location with adequate air circulation to prevent internal heat buildup.
Use the dimensions of the printer as a guideline for the minimum clearances to the unit.
Allow for adequate clearance in front of the unit to accommodate the unit with its covers open.
Do not install the unit near heat sources such as radiators or air ducts or in a place subject to direct
sunlight, excessive dust, mechanical vibration, or shock.

2.2 Moisture condensation

If the unit is brought directly from a cold to a warm location or is placed in a a very damp room, moisture may
condense inside the unit. Should this occur, print quality may not be optimal.
Leave the unit unplugged in a warm, dry room for several hours before using to allow any moisture to
evaporate.
Caution: For safety purposes, Ethernet is not intended for a direct connection outside of the building.
Attention: Pour des raisons de sécurité, Ethernet n'est pas conçu pour une connexion directe à l'extérieur
du bâtiment.
September 2018
2
Section
19