Section 2: Setup And Installation Procedures; Choosing A Good Location; About Moisture Condensation; Unpacking And Inspection - HID Fargo DTC4500 User Manual

© 2010 HID Global Corporation

Section 2: Setup and Installation Procedures

This section describes the setup and installation for the DTC4500 Card Printer.

Choosing a Good Location

Follow these guidelines:
•
Place the unit in a location with adequate air circulation to prevent internal heat build up.
•
Use the Printer's dimensions as a guideline for the minimum clearances to the unit. (Note: Allow for
adequate clearance in front of the unit to accommodate the unit with its Covers open.)
•
Do not install unit near heat sources such as radiators or air ducts or in a place subject to direct
sunlight, excessive dust, mechanical vibration or shock.

About Moisture Condensation

If the unit is brought directly from a cold to a warm location or is placed in a very damp room, moisture
may condense inside the unit. Should this occur, print quality may not be optimum.
Leave the unit turned Off in a warm, dry room for several hours before using. This will allow the moisture
to evaporate.
Caution: For safety purposes, Ethernet is not intended for a direct connection outside of the
building.

Unpacking and Inspection

While unpacking your Printer, inspect the carton to ensure that no damage has occurred during shipping.
Make sure that all supplied accessories are included with your unit.
Check that the following items are included:
•
Power Supply
•
US / EU Power Cable
•
USB cable (2.0)
•
Software Installation CD/User Guide
•
User Guide
•
Warranty Statement, Registration Card and Compliancy Document
DTC4500 Card Printer/Encoder User Guide
All rights reserved
16