Power Switch; Figure 6-1. Power Switch - Thermo Scientific STERI-CYCLE i160 User Manual

6
Handling and control

Power switch

Power switch

Figure 6-1. Power switch

The power switch is mounted in the side panel of the unit.
• Powering up: Press the power switch; the switch illumination comes on.
• After a short beep the blank screen vanishes and the touchscreen is displayed.
• The control loop sensors pass the heat-up phase
• Powering down: Press the power switch; the switch illumination goes off.
i160 / i250
S
6-2 TERI-CYCLE
on page 6-7).
("Heat-up phase of the control loop sensors"
Thermo Scientific