Chapter 4 Start-Up; Adapting The Unit To The Ambient Atmosphere; Preparing The Workspace - Thermo Scientific STERI-CYCLE i160 User Manual

Start-up
Table of Contents
•

"Adapting the unit to the ambient atmosphere"

•

"Preparing the workspace"

• "Installing the "MAX" fill level indicator and the pre-filter"
• "Install the air duct"
• "Installing the shelf system"
• "Mount the split inserts (optional) into the STERI-CYCLE i250"
• "Gas connection"
• "Power supply connection"
• "Connecting the USB interface:"
• "Connecting the alarm contact:"
Adapting the unit to the ambient atmosphere
CAUTION Adapting the unit to the ambient atmosphere!
Prior to commissioning allow sufficient time the unit to adapt to the ambient atmosphere.
• Prior to powering up, place the unit for approx. 2 hours in the operating room at the expected
prevailing operating room temperature.
• Open device doors.
Preparing the workspace
Upon delivery, the CO
decontaminated.
Before the decontamination is performed, the following workspace components must be cleaned:
• Support rail
• Shelf support
Thermo Scientific
on page 4-1
on page 4-4
on page 4-7
on page 4-10
on page 4-15
on page 4-16
on page 4-16
incubator is not in a sterile state. Before the initial start-up, the device must be
2
on page 4-1
on page 4-2
on page 4-9
S
TERI-CYCLE
4
i160 / i250
4-1