4
Start-up
Installing the HEPA-filter and the water reservoir cover panel
5. Place the airbox
1
2
Figure 4-5. Place the airbox onto the Water reservoir cover panel.
6. Mount the water reservoir cover panel on the bottom of the workspace.
7. Lift the water reservoir cover at the front side and push it towards the rear wall
1
Figure 4-6. Installing the airbox
8. Push the water reservoir cover panel all the way towards the rear wall. Doing so lets the cover panel
slide into its final position in the reservoir and the tube end of the airbox into the fan outlet.
9. Let the front edge of the water reservoir cover slide into the water reservoir
airbox tubing slides into the fan outlet.
i160 / i250
S
4-6
TERI-CYCLE
(1/Figure
4-5) onto its seat
1
2
(2/Figure
4-5) on the water reservoir cover panel.
1
(1/Figure
4-6).
(2/Figure
4-6). The
Thermo Scientific