Shut-down
Table of Contents
•
„Shutting the device down"
Shutting the device down
CAUTION Contamination hazard!
If the workspace surfaces are contaminated, germs may spread to the environment of the oven.
In case of a shut-down, the device must be decontaminated!
1. Remove the culture containers and all accessories from the workspace.
2. Procure a collecting vessel of sufficient capacity.
3. Hold open end of hose into collecting vessel and lock drain hose valve safely into receptacle.
4. The water reservoir starts draining.
Figure 7-1. Drain valve of water reservoir
5. Allow the water reservoir to drain completely into the collecting vessel.
6. Remove drain hose valve again.
7. Start the Steri-Run decontamination routine
Thermo Scientific
on
page 7-1
(„Launching steri-run"
7
on
page
6-16).
i160 / i250
S
TERI-CYCLE
7-1