Installing The "Max" Fill Level Indicator And The Pre-Filter; Figure 4-1. "Max" Fill Level Indicator - Thermo Scientific STERI-CYCLE i160 User Manual

4
Start-up

Installing the "MAX" fill level indicator and the pre-filter

• Prefilter
• Air duct
• Airbox
• Shelves
• Workspace surfaces
• Glass door seal
• glass door/gas-tight screen.
Note Decontamination:
For details about the cleaning and disinfection of the device see chapter
disinfection"
Installing the "MAX" fill level indicator and the pre-filter
The "MAX" fill level indicator and the pre-filter can be installed without any need for tools:
1. Make sure that the tube is removed from the drain valve
2. Check whether the drain
obstruction; it is needed for discharging the water through the drain valve
front side of the unit.
3. Suspend the "MAX" fill level indicator
cover panel

Figure 4-1. "MAX" fill level indicator

i160 / i250
S
4-2 TERI-CYCLE
on page 8-1.
(2/Figure
(5/Figure 4-1).
2 1
(3/Figure
4-2) in the front section of the water reservoir is free of
(1/Figure 4-1) in the slot provided in the water reservoir
5
"Cleaning and
4-2).
(3/Figure 4-2) on the
Thermo Scientific