Error Memory Structure - Thermo Scientific STERI-CYCLE i160 User Manual

12
Annex: Data communication

Error memory structure

Note on
Bit
0x00
0x01
0x02
0x03
0x04
0x05
0x06
0x07
0x08
0x09
0x0A
0x0B
0x0C
0x0D
0x0E
0x0F
Error memory structure
The error memory contains 22 error messages. A query is responded with 22 data sets with a colon as
separator and can be queried using the following commands:
Query:
Query:
These data sets consist of 11 byte and are encrypted in 21 ASCII characters prior to data transmission.
Example: The byte 0x23 is converted into the ASCII characters 0x32 ("2") and 0x33 ("3").
• Byte 1 consists of 1 characters,
• Bytes 2 - 11 consist of 2 characters.
Therefore, a response consists of 1+(10 x 2) = 21 data bytes plus separator.
A data set always delivers the date, the time, the faulty control loop, the device status, and the error
message.
i160 / i250
S
12-8 TERI-CYCLE
*3)
disinfection and auto-start run status:
Disinfection
Steri-run not activated
Initialization
Wait until open door time expires
Wait until door closes
Start
Heating
Holding
Condensation
Cooling
Drying
Wait for enable
Cancellation
-
-
-
-
?:2300:00::cc<CR>
Reading the first 11 error memory entries.
?:2301:00::cc<CR>
Reading the first 11 error memory entries.
auto-start
auto-start not activated
Initialization
Wait until open door time expires
Wait until door closes
Start
Heating
Perform reverse voltage adjustment
Waiting period 1
Set tolerance range
Build up stable moisture
Perform reverse voltage adjustment
Waiting period 2
Determine offset
Read out, check offset
Release
Cancellation
Thermo Scientific