Figure 5-2. "Max" Fill Level Indicator - Thermo Scientific STERI-CYCLE i160 User Manual

5
Operation
Starting operation
5. Do not exceed the maximum level mark "MAX"
water reservoir

Figure 5-2. "MAX" fill level indicator

6. Wipe off excess water from the cover of the water reservoir.
7. Reinstall pre-filter
8. Reinstall the bottom shelf or close flap over cut-out for filling.
9. Make sure that the valves of the CO
10. Turn on the device using the power switch.
11. Adjust set values for temperature and CO
Starting the device:
12. Start the device with the auto-start routine (see
13. The auto-start progress indicator appears on the display, and the automatic start routine is run.
14. The temperature control adjusts the temperature to the selected set value, humidity rises.
15. When temperature and relative humidity are constant, the automatic adjustment of the CO
measuring system is performed.
16. The CO
17. If the auto-start routine has been completed, the progress indicator is hidden, and the main menu
is displayed. The device is operational.
i160 / i250
S
5-4 TERI-CYCLE
(5/Figure 5-2) is 3 l.
2 1
5
(2/Figure 5-1).
-/O control supplies the set amount of CO
2 2
(1/Figure 5-2). The maximum fill volume of the
/O /N supply system are open.
2 2 2
/O concentration on the iCan™ touchscreen.
2 2
"Activating the auto-start routine"
-/O .
2 2
on page 6-14).
-/O
2 2
Thermo Scientific