Water Reservoir - Thermo Scientific STERI-CYCLE i160 User Manual

3
Description of the device
Workspace Components
2
1
Figure 3-12. S i160 with threefold gas-tight screen
TERI-CYCLE
Each door of the gas-tight screen (2/Figure 3-12) is separately locked (1/Figure 3-12).

Water reservoir

The water reservoir is sunk into the interior container bottom and separated from the workspace by
means of a cover panel. A drain (2/Figure 3-13) provided in the front section of the water reservoir
allows for quickly draining the water through a drain valve (3/Figure 3-13) located at the front section
of the device.
Placed on the front section of the water reservoir cover is a pre-filter (4/Figure 3-13). The pre-filter
consists of a dual-layer wire mesh with a silicone frame and is autoclavable as well as heat-resistant. The
pre-filter must remain installed in the device during the Steri-run decontamination routine, but needs
to be removed for refilling the water reservoir. The pre-filter must remain installed in the device during
the Steri-run decontamination routine, but needs to be removed for refilling the water reservoir.
i160 / i250
S
Thermo Scientific TERI-CYCLE 3-19