Shelf Support Installation; Levelling The Device; Figure 4-8. Shelf Support Installation - Thermo Scientific STERI-CYCLE i160 User Manual

4
Start-up
Installing the shelf system

Shelf support installation

Figure 4-8. Shelf support installation

1. Insert the shelf supports into the perforations of the support rail with the bar facing down.
2. Make sure that the two vertical elements of the shelf support are flush with the support rail.
Installing the shelves:
1. Slide the shelves tilt with the protection device
tilt protection is also used as a guide for the shelf.
2. Slightly raise the shelf so that the withdrawal stop
supports.
3. Make sure that the shelf support is positioned in the two tilt protections in a way that allows it to
move freely.
Note With the S
at the bottom position only.

Levelling the device

1. Position a bubble level onto the center shelf or onto the roller holder.
i160 / i250
S
4-8 TERI-CYCLE
i160 incubator be sure to install the insert with the cut-out for refilling
TERI-CYCLE
(5/Figure 4-8) ahead onto the shelf support. The
(6/Figure 4-8) can be routed over the shelf
Thermo Scientific