Setting The O2 Set Value; Figure 6-10. Setting The Co2 Set Value - Thermo Scientific STERI-CYCLE i160 User Manual

6
Handling and control

Setting the O2 set value

3. To set the CO
• Press the Set value key.
To increase the set value:
• Press the + key.
To reduce the set value:
• Press the - key.
4. To accept and save the set value:
• Press the Enter key.
• The system returns to the main menu. The CO
in the workspace.
Figure 6-10. Setting the CO
Note Deactivating the CO
To deactivate the CO
If the control loop is deactivated, error monitoring is enabled as well.
Gas monitoring:
The switching state of the CO
monitoring system. The gas monitoring system remains active even when the CO
switched off.
Setting the O
This setting is possible only on versions with the optional O
1. Press the O
• The O
i160 / i250
S
6-10 TERI-CYCLE
set value:
2
set value
2
control loop:
2
control, the set value is set to 0 %.
2
control loop does not affect the function of the optional gas
2
set value
2
display key.
2
menu is displayed.
2
display shows the actual value currently measured
2
-/N control.
2 2
control is
2
Thermo Scientific