Mounting The Simatic Drive Controller - Siemens SIMATIC S7-1500 System Manual

7.2

Mounting the SIMATIC Drive Controller

Requirement
The SIMATIC Drive Controller is fitted in a control cabinet together with the SINAMICS
components.
Requirements for installing a SIMATIC Drive Controller:
• The control cabinet has been installed and wired.
• The SINAMICS components have been installed and wired.
• The components and tools required for installation are to hand.
• T10 screwdriver for the M3 screws in the spacer are to hand.
• For installation on the control cabinet wall: Tool for M6 screws
Designs
The SIMATIC Drive Controller is fitted to the wall of the control cabinet in one of the following
ways:
• Installation with spacer
• Installation without spacer
The SIMATIC Drive Controller is supplied with a spacer fitted.
The spacers increase the depth of the SIMATIC Drive Controller to 270 mm and allow flush
installation with 270 mm-deep power units.
Installing SIMATIC Drive Controller with spacers
Proceed as follows:
1
SIMATIC Drive Controller
System Manual, 11/2023, A5E46600094-AD
Attach the SIMATIC Drive Controller to the
control cabinet wall with one M6 screw
each at ① and ②.
Tightening torque: 6 Nm (53.1 lbf in)
7.2 Mounting the SIMATIC Drive Controller
Installation
115