Maintenance And Service; Overview - Siemens SIMOTION D410 Series Commissioning Manual

Maintenance and service

5.1

Overview

Introduction
It is possible to distinguish between the following scenarios when replacing and updating
components:
● Replacing modules (spare part scenario)
● Adapting a project (new device type/device version)
● Performing a firmware and project update
D410
Commissioning Manual, 05/2009
– For information on removing and replacing the SIMOTION D410, refer to the section
titled Removing and replacing the SIMOTION D410 (Page 143).
– For information on replacing DRIVE-CLiQ components, refer to the section titled
Replacing DRIVE-CLiQ components (Page 144).
– For information on replacing SIMOTION D410 fans, refer to the section titled
Replacing the fan (Page 147).
– For information on replacing a CompactFlash card, refer to the section titled Replacing
the CompactFlash card (Page 149).
The project needs to be adapted if you want to change the type (e.g. D410 DP -> D410
PN) or version of the SIMOTION device in your existing project.
– For information on replacing a SIMOTION device in HW Config, refer to the section
titled Replacing the SIMOTION device in HW Config (Page 151).
– For information on upgrading the device version of SINAMICS components, refer to
the section titled Upgrading the device version of SINAMICS components (Page 153).
– For information on upgrading technology packages, refer to the section titled
Upgrading technology packages (Page 154).
– For information on upgrading a library, refer to the section titled Upgrade the libraries
(Page 155).
– For information on backing up variables, refer to the section titled Backing up variables
(Page 155).
– For information on upgrading a CompactFlash Card bootloader, refer to the section
titled Upgrading the CompactFlash Card's bootloader (Page 156).
– For information on downloading a project to the target system, refer to the section
titled Downloading the project to the target system (Page 156).
– For information on performing a firmware update using a CompactFlash Card, refer to
the section titled Firmware update using a CompactFlash Card (Page 158).
– For information on performing a firmware and project update using IT DIAG, refer to
the section titled Firmware and project update using IT DIAG (Page 162).
– For information on performing a firmware and project update using the device update
tool, refer to the section titled Firmware and project update using the device update
5
141