Igmp Bandwidth Set Command; Igmp Bandwidth Delete Command; Igmp Bandwidth Port Commands; Igmp Bandwidth Port Disable Command - ZyXEL Communications IES-1248-71 User Manual

This command sets the default bandwidth for multicast channels for which you have not
configured bandwidth requirements yet. Multicast bandwidth settings on channels (using the
switch igmpsnoop bandwidth set command) have higher priority over this default
setting.

50.4.2 IGMP Bandwidth Set Command

Syntax:
ras> switch igmpsnoop bandwidth set <index> <start-mcast-ip> <end-mcast-ip>
<bandwidth>
where
<index>
<start-mcast-
ip>
<end-mcast-ip>
<bandwidth>
This command configures bandwidth allocation for the multicast channel(s). For multicast
channel(s) for which you have not configured bandwidth settings, the default multicast
bandwidth setting applies (see the switch igmpsnoop bandwidth default
command).

50.4.3 IGMP Bandwidth Delete Command

Syntax:
ras> switch igmpsnoop bandwidth delete <index>
where
<index>
This command removes the specified multicast bandwidth configuration profile.

50.5 IGMP Bandwidth Port Commands

Use the IGMP bandwidth port commands to set up bandwidth budgets for multicast traffic on
specific ports.

50.5.1 IGMP Bandwidth Port Disable Command

Syntax:
ras> switch igmpsnoop bandwidth port disable <portlist>
IES-1248-71/73 User's Guide
1..96; a unique number for this setting.
=
224.0.0.0..239.255.255.255; the beginning of the multicast
=
range.
224.0.0.0..239.255.255.255; the end of the multicast range. It
=
must be greater than <start-mcast-ip>.
1..100000, in units of kbps
=
1..96; a unique number for this setting.
=
Chapter 50 IGMP Commands
339