Switch Port Gvrp Commands - ZyXEL Communications MSC1000G User Manual

MSC1000G User's Guide
The following example sets ports the subtending 1 Gigabit Ethernet interface to accept only
tagged frames.
ras switch port frametype sub1 tag

28.9.6 switch port gvrp Commands

Use the
switch port gvrp
interfaces.
28.9.6.1 switch port gvrp disable Command
Syntax:
switch port gvrp disable <giga-port>
This command turns off GVRP on a Gigabit Ethernet interface.
GVRP (GARP VLAN Registration Protocol) is a registration protocol that defines a way for
switches to register necessary VLAN members on ports across the network. Disable GVRP to
have the MSC not propagate VLAN information to other devices.
The following example turns off GVRP on the subtending 1 Gigabit Ethernet interface.
ras> switch port gvrp disable sub1
28.9.6.2 switch port gvrp enable Command
Syntax:
switch port gvrp enable <giga-port>
This command turns on GVRP on a Gigabit Ethernet interface.
GVRP (GARP VLAN Registration Protocol) is a registration protocol that defines a way for
switches to register necessary VLAN members on ports across the network. The MSC
propagates VLAN information to other devices when you enable GVRP.
The following example turns on GVRP on the subtending 1 Gigabit Ethernet interface.
ras> switch port gvrp enable sub1
28.9.7 switch port mode Command
Syntax:
switch port mode <giga-port> uplink|subtend
476
commands to configure GVRP settings for the Gigabit Ethernet
Chapter 28 switch Commands