Switch Port Priority Command - ZyXEL Communications MSC1000G User Manual

MSC1000G User's Guide
where
<name>
This command sets the name of a Gigabit Ethernet interface.
The following example sets the name of the subtending 1 Gigabit Ethernet interface to
ras> switch port name sub1 xyz

28.9.10 switch port priority Command

Syntax:
switch port priority <giga-port> <priority>
where
<giga-port>
<priority>
This command sets the default ingress user priority of a Gigabit Ethernet interface.
The following example sets the default priority of the subtending 1 Gigabit Ethernet interface
to 3.
ras> switch port priority sub1 3
28.9.11 switch port pvid Command
Syntax:
switch port pvid <giga-port> <vid>
where
<giga-port>
<pvid>
480
= A name to identify the port.
= This represents Gigabit Ethernet uplink ports, subtending ports
or all ports. Use
sub1|sub2|up1|up2|all i
enabled. Use
tsub|tup|all
= The default ingress priority (0~7).
= This represents Gigabit Ethernet uplink ports, subtending ports
or all ports. Use
sub1|sub2|up1|up2|all i
enabled. Use
tsub|tup|all
= The default Port VLAN ID (PVID) assigned to untagged frames
or priority-tagged frames received on this port. 1~4094.
f trunking is not
if trunking is enabled.
f trunking is not
if trunking is enabled.
Chapter 28 switch Commands
.
xyz