Turning An Analog Output Over-Range Feature On/Off - Teledyne T300 Operation Manual

Teledyne API – Model T300/T300M CO Analyzer

5.9.3.8. TURNING AN ANALOG OUTPUT OVER-RANGE FEATURE ON/OFF

Toggle this
button to turn
the Over-
Range feature
ON/OFF
06864B DCN6314
In its default configuration, a ± 5% over-range is available on each of the T300/T300M
Analyzer's analog outputs. This over-range can be disabled if your recording device is
sensitive to excess voltage or current.
To turn the over-range feature on or off, select the ANALOG I/O CONFIGURATION
submenu (see Figure 5-3) then press:
AIO CONFIGURATION SUBMENU
DIAG
PREV NEXT
DIAG AIO
SET>
Continue pressing SET> until you reach the
DIAG AIO
<SET SET>
DIAG AIO
SET>
DIAG AIO
<SET SET>
DIAG AIO
ON
DIAG AIO
OFF
From the
ANALOG I/O CONFIGURATION
ENTR
AOUTS CALIBRATED: NO
CAL
output to be configured
CONC_OUT_2: 5V, OVR, NOCAL
EDIT
CONC_OUT_2: RANGE: 5V
EDIT
CONC_OUT_2: OVERRANGE: ON
EDIT
CONC_OUT_2: OVERRANGE: ON
CONC_OUT_2: OVERRANGE: OFF
Setup Menu
EXIT
EXIT
EXIT
EXIT
EXIT
ENTR EXIT
ENTR EXIT
133