Teledyne T300 Operation Manual page 205

Teledyne API – Model T300/T300M CO Analyzer
Only appears if the DUAL or
AUTO range modes are selected.
Use these buttons to choose the
appropriate range.
Repeat entire procedure for each
range.
The CO span concentration value
is automatically default to
40.0 Conc.
If this is not the the concentration of
the span gas being used, toggle
these buttons to set the correct
concentration of the CO
calibration gas.
I
MPORTANT
06864B DCN6314
SAMPLE
< TST TST >
SAMPLE
CO O2
SAMPLE
LOW HIGH
M-P CAL
<TST TST> ZERO SPAN
M-P CAL CO SPAN CONC:40.0 Conc
0 0 4
For this Initial Calibration it is important to independently verify the
PRECISE CO Concentration Value of the SPAN gas.
If the source of the Span Gas is from a Calibrated Bottle, use the exact
concentration value printed on the bottle.
RANGE=50.0PPM CO=XX.XX
CAL MSG SETUP
GAS TO CAL:CO
ENTR
RANGE TO CAL:LOW
ENTR
RANGE=50.0PPM CO=XX.XX
CONC
0 .0 0 ENTR EXIT
I R
MPACT ON EADINGS OR
Calibration Procedures
Only appears if either
the O2 or CO2
Sensors are installed.
EXIT
EXIT
EXIT
EXIT ignores the new
setting and returns to
the previous display.
ENTR accepts the new
setting and returns to
the
CONCENTRATION
MENU.
D
ATA
203