Pneumatic Connections For Zero Scrubber/Pressurized Span Option; Figure 3-25: Pneumatic Connections - Zero Scrubber/Pressurized Span Calibration Valves (Opt 50E) - Teledyne T300 Operation Manual

Getting Started

3.3.2.7. PNEUMATIC CONNECTIONS FOR ZERO SCRUBBER/PRESSURIZED SPAN OPTION

Source of
SAMPLE GAS
Removed during
calibration
Calibrated
CO Gas
at span gas
concentration
(Adjust to 30
Figure 3-25: Pneumatic Connections – Zero Scrubber/Pressurized Span Calibration Valves (Opt 50E)
70
psig)
S G S
AMPLE AS OURCE
Attach a sample inlet line to the sample inlet port. The SAMPLE input line should not
be more than 2 meters long.
•
Maximum pressure of any gas at the sample inlet should not exceed 1.5 in-hg above
ambient pressure and ideally should equal ambient atmospheric pressure.
•
In applications where the sample gas is received from a pressurized manifold, a
vent must be placed on the sample gas before it enters the analyzer.
C G S
ALIBRATION AS OURCES
S G :
PAN AS
•
Attach a gas line from the pressurized source of calibration gas (e.g. a bottle of
NIST-SRM gas) to the span inlet.
•
Span gas can by generated by a T700 Dynamic Dilution Calibrator.
Z A :
ERO IR
•
Zero air is supplied internally via a zero air scrubber that draws ambient air through
the ZERO AIR inlet.
I G V
NPUT AS ENTING
The zero air supply and sample gas line MUST be vented in order to ensure that the
gases input do not exceed the maximum inlet pressure of the analyzer as well as to
prevent back diffusion and pressure effects. These vents should be:
•
At least 0.2m long;
•
No more than 2m long and;
•
Vented outside the shelter or immediate area surrounding the instrument.
A similar vent line should be connected to the VENT SPAN outlet on the back of the
analyzer.
Teledyne API – Model T300/T300M CO Analyzer
VENT
here if input
is pressurized
SAMPLE
EXHAUST
VENT
VENT SPAN
PRESSURE SPAN
ZERO AIR
Instrument
Chassis
06864B DCN6314