Zero/Span Point Calibration Procedure - Teledyne T300 Operation Manual

Calibration Procedures
Only appears if the DUAL or
AUTO range modes are selected.
Use these buttons to choose the
appropriate range.
Repeat entire procedure for each
range.
The default CO span concentration
value is 40.0 Conc.
If this is not the the concentration of
the span gas being used, toggle
these buttons to set the correct
concentration of the CO
calibration gas.
I
MPORTANT

9.3.3.2. ZERO/SPAN POINT CALIBRATION PROCEDURE

210
SAMPLE
< TST TST > CAL CALZ
SAMPLE
CO O2
SAMPLE
LOW HIGH
M-P CAL
<TST TST> ZERO SPAN
M-P CAL CO SPAN CONC:40.0 Conc
0 0
For this Initial Calibration it is important to independently verify the
PRECISE CO Concentration Value of the SPAN gas.
If the source of the Span Gas is from a Calibrated Bottle, use the exact
concentration value printed on the bottle.
The zero and cal operations are initiated directly and independently with dedicated
buttons (CALZ & CALS).
Teledyne API – Model T300/T300M CO Analyzer
RANGE=50.0PPM CO=XX.XX
CALS
GAS TO CAL:CO
ENTR
RANGE TO CAL:LOW
ENTR
RANGE=50.0PPM CO=XX.XX
CONC
4 0 .0 0 ENTR EXIT
I R
MPACT ON EADINGS OR
SETUP
Only appears if either
the O or or the CO
2
sensor is installed.
EXIT
EXIT
EXIT
EXIT ignores the new
setting and returns to
the previous display.
ENTR accepts the new
setting and returns to
the
CONCENTRATION
MENU.
D
ATA
06864B DCN6314
2