Getting Started; Unpacking The T300/T300M Analyzer - Teledyne T300 Operation Manual

GETTING STARTED

3.

3.1. UNPACKING THE T300/T300M ANALYZER

ATTENTION
Note
06864B DCN6314
This section first introduces you to the instrument, then presents the procedures for
getting started, i.e., unpacking and inspection, making electrical and pneumatic
connections, and conducting an initial calibration check.
To avoid personal injury, always use two persons to lift and carry the T300/T300M.
COULD DAMAGE INSTRUMENT AND VOID WARRANTY
Printed Circuit Assemblies (PCAs) are sensitive to electro-static
discharges too small to be felt by the human nervous system. Failure to
use ESD protection when working with electronic assemblies will void
the instrument warranty. See A Primer on Electro-Static Discharge in
this manual for more information on preventing ESD damage.
Do not operate this instrument until you've removed dust plugs from SAMPLE and
EXHAUST ports on the rear panel!
Teledyne API recommends that you store shipping containers/materials
for future use if/when the instrument should be returned to the factory for
repair and/or calibration service. See Warranty section in this manual and
shipping procedures on our Website at
under Customer Support > Return Authorization.
Verify that there is no apparent external shipping damage. If damage has occurred,
please advise the shipper first, then Teledyne API.
CAUTION
G S H
ENERAL AFETY AZARD
CAUTION!
http://www.teledyne-api.com
35