Signal I/O - Teledyne T300 Operation Manual

Setup Menu

5.9.1. SIGNAL I/O

I
MPORTANT
SAMPLE RANGE=50.0 PPM
<TST TST> CAL
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG
SETUP X.X ENTER PASSWORD:818
8 1 8
118
The signal I/O diagnostic mode allows a user to review and change the digital and
analog input/output functions of the analyzer. Refer to Appendix A-4 for a full list of
the parameters available for review under this menu.
Any changes of signal I/O settings will remain in effect only until the
signal I/O menu is exited. Exceptions are the ozone generator override
and the flow sensor calibration, which remain as entered when exiting.
Access the SIGNAL I/O test mode from the DIAG Menu:
CO= XXXX
SETUP
MORE EXIT
DIAG
EXIT
DIAG I/O
PREV
ENTR EXIT
DIAG I/O
PREV NEXT JUMP
DIAG I/O
0
EXAMPLE
DIAG I/O
2
DIAG I/O
PREV NEXT JUMP
Teledyne API – Model T300/T300M CO Analyzer
I R
MPACT ON EADINGS OR
SIGNAL I/O
NEXT ENTR
0) EXT_ZERO_CAL=OFF
NEXT EDIT PRNT
1)EXT_SPAN_CAL=OFF
EDIT PRNT
JUMPTO: 0
0 JUMP ENTR
JUMPTO: 22
2 JUMP ENTR
22) RELAY_WATCHDOG=ON
OFF PRNT EXIT
On status signals this
button toggles the
signal ON / OFF.
D
ATA
EXIT
EXIT
Press PREV and
NEXT to cycle through
the signal types.
EXIT Press JUMP to go
directly to a specific
signal
(see Appendix A for a list
of all I/O SIGNALS)
EXIT
Toggle to set
location No. of the
signal to JUMP to.
EXIT
Pressing PRNT will send a formatted
printout to the serial port and can be
captured with a computer or other
output device.
06864B DCN6314