Single Range Mode (Sngl) - Teledyne T300 Operation Manual

Setup Menu

5.4.3.1. SINGLE RANGE MODE (SNGL)

Toggle these keys
to select the upper
SPAN limit for the
shared CO
reporting range.
Toggle these keys to select the
upper SPAN limit for the CO
reporting range
NOTE
Only appears if the optional CO
O Sensor is installed.
2
102
Single Range Mode (SNGL) is the default reporting range mode for the analyzer.
When the single range mode is selected (SNGL), all analog CO concentration outputs
(A1 and A2) are slaved together and set to the same reporting range limits (e.g. 500.0
ppb). The span limit of this reporting range can be set to any value within the physical
range of the analyzer.
Although both outputs share the same concentration reporting range, the electronic
signal ranges of the analog outputs may still be configured for different values (e.g. 0-5
VDC, 0-10 VDC, etc; see Section 5.9.3.1)
To select SNGL range mode and to set the upper limit of the range, press:
SAMPLE
<TST TST> CAL
SETUP X.X
CFG DAS
SETUP X.X
MODE SET UNIT
SETUP X.X
SNGL DUAL AUTO
SETUP X.X
SNGL DUAL AUTO
SETUP X.X
MODE SET
SETUP X.X
0 0
SETUP X.X
1 0
O
or
2 2
or
2
Teledyne API – Model T300/T300M CO Analyzer
RANGE=50.00 PPB CO=XX.XX
PRIMARY SETUP MENU
RNGE PASS CLK MORE
RANGE MODE MENU
DIL
RANGE MODE:SNGL
ENTR EXIT
RANGE MODE:SNGL
ENTR
RANGE CONTROL MENU
UNIT DIL
RANGE:500.0 Conc
5 0 0 .0 ENTR EXIT
O2 RANGE:100.00 %
0 .0 0 ENTR EXIT
SETUP
EXIT
EXIT
EXIT
EXIT
EXIT discards the new
setting.
ENTR accepts the
new setting.
06864B DCN6314