Section 6 - Teledyne T300 Operation Manual

Teledyne API – Model T300/T300M CO Analyzer
Note
I
MPORTANT
06864B DCN6314
USB C
ONNECTION
For direct communication between the analyzer and a PC, connect a USB cable between
the analyzer and desktop or laptop USB ports. The baud rate for the analyzer and the
computer must match; you may elect to change one or the other: to view and/or change
the analyzer's baud rate, see Section 6.2.2.
If this option is installed, the COM2 port cannot be used for anything
other than Multidrop communication.
For configuration, see 6.6.
RS-232 C
ONNECTION
For RS-232 communications with data terminal equipment (DTE) or with data
communication equipment (DCE) connect either a DB9-female-to-DB9-female cable
(Teledyne API part number WR000077) or a DB9-female-to-DB25-male cable (Option
60A, Section 1.4), as applicable, from the analyzer's rear panel RS-232 port to the
device. Adjust the DCE-DTE switch (Figure 3-4) to select DTE or DCE as appropriate.
Configuration: Sections 5.7 and 6.3.
Cables that appear to be compatible because of matching connectors
may incorporate internal wiring that makes the link inoperable. Check
cables acquired from sources other than Teledyne API for pin
assignments (Figure 3-14) before using.
I R
MPACT ON EADINGS OR
Getting Started
D
ATA
55