Autocal With Auto Or Dual Reporting Ranges Modes Selected - Teledyne T300 Operation Manual

Teledyne API – Model T300/T300M CO Analyzer
Toggle buttons to set
duration for each iteration
of the sequence:
Set in Decimal minutes
from 0.1 – 60.0.
Toggle button between
Off and ON.
Display show:
SEQ 2) ZERO–SPAN, 2:00:30
Sequence
MODE

9.4.1.1. AUTOCAL WITH AUTO OR DUAL REPORTING RANGES MODES SELECTED

SETUP X.X
<SET
SETUP X.X
LOW
SETUP X.X
<SET
SETUP X.X
PREV NEXT
Note
06864B DCN6314
CONTINUED FROM PREVIOUS PAGE
SETUP X.X
<SET SET>
SETUP X.X
3 0
SETUP X.X
<SET SET>
SETUP X.X
<SET SET>
SETUP X.X
ON
SETUP X.X
<SET SET> EDIT
SETUP X.X
Delta Time
Delta Days
PREV NEXT
If the T300/T300M Analyzer is set for either the Dual or Auto reporting range modes,
the following three steps will appear at the beginning of the AutoCal setup routine:
RANGE TO CAL: LOW
EDIT
RANGE TO CAL: LOW
HIGH
RANGE TO CAL: HIGH
EDIT
SEQ 2) ZERO–SPAN, 2:00:30
MODE SET
In order to automatically calibrate both the HIGH and LOW ranges, you
must set up a separate sequence for each.
DELTA TIME
DURATION:15.0 MINUTES
EDIT
DURATION 15.0MINUTES
.0 ENTR
DURATION:30.0 MINUTES
EDIT
CALIBRATE: OFF
EDIT
CALIBRATE: OFF
ENTR
CALIBRATE: ON
SEQ 2) ZERO–SPAN, 2:00:30
MODE SET
EXIT
ENTR SETUP
EXIT
EXIT
Calibration Procedures
EXIT
EXIT
EXIT
EXIT
EXIT
EXIT
EXIT returns
to the SETUP
EXIT Menu.
EXIT returns to the
PRIMARY SETUP
Menu.
217