Teledyne T300 Operation Manual page 117

Teledyne API – Model T300/T300M CO Analyzer
SAMPLE
<TST TST> CAL
SETUP X.X
CFG DAS RNGE PASS CLK
SETUP X.X
COMM VARS
SETUP X.X
8 1
Toggle these
buttons to enter
the correct
SETUP X.X
PASSWORD.
PREV NEXT
SETUP X.X
PREV NEXT
SETUP X.X
PREV NEXT
SETUP X.X
PREV NEXT
SETUP X.X
PREV NEXT
SETUP X.X
PREV NEXT
Press NEXT for additional
VARS; press NEXT or
PREV to move back and
forth throughout the list of
VARS.
06864B DCN6314
To access and navigate the VARS menu, use the following button sequence.
RANGE=500.0 PPM CO= XXXX
SETUP
PRIMARY SETUP MENU
MORE
SECONDARY SETUP MENU
DIAG
ENTER PASSWORD:818
8 ENTR
0) DAS_HOLD_OFF=15.0 Minutes
JUMP EDIT PRNT EXIT
1) CONC_PRECISION=AUTO
JUMP EDIT PRNT EXIT
2) DYN_ZERO=OFF
JUMP EDIT PRNT EXIT
3) DYN_SPAN=OFF
JUMP EDIT PRNT EXIT
4) CLOCK_ADJUST=0 Sec/Day
JUMP EDIT ENTR EXIT
5) STABIL_GAS=CO
JUMP EDIT PRNT EXIT
Concentration display
continuously cycles
through all gasses.
EXIT
EXIT discards the new
EXIT
EXIT
SETUP X.X DAS_HOLD_OFF=15.0 Minutes
1 5 .0
SETUP X.X CONC_PRECISION=AUTO
AUTO 1 2 3
SETUP X.X DYN_ZERO=OFF
OFF
SETUP X.X DYN_SPAN=OFF
OFF
SETUP X.X CLOCK_ADJUST=0 Sec/Day
+ 0 0
SETUP X.X STABIL_GAS=O2
CO CO2 O2
In all cases:
setting.
ENTR accepts the
new setting.
ENTR EXIT
Toggle these buttons to set
the iDAS HOLDOFF time
period in minutes
(MAX = 20 minutes).
4 ENTR EXIT
Use these buttons to select
the precision of the o33
concentration display.
ENTR EXIT
Toggle this button to turn
the Dynamic Zero
calibration feature ON/
ENTR EXIT
Toggle this button to turn
the Dynamic Span
calibration feature ON/
ENTR EXIT
Enter sign and number of
seconds per day the clock
gains (-) or loses(+).
Use these buttons to select
ENTR EXIT
which gas will be reported
by the sTABIL test
(O is only available if the
2
optional O
Setup Menu
OFF.
OFF.
function.
sensor is
2
installed)
115