Analog Output - Teledyne T300 Operation Manual

Teledyne API – Model T300/T300M CO Analyzer

5.9.2. ANALOG OUTPUT

SAMPLE RANGE=50.0 PPM
<TST TST> CAL
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG
·
Pressing the button under "0%" pause
the test. Brackets will appear around the
value: EXAMPLE: [20%]
·
Pressing the same button again will
resume the test.
06864B DCN6314
Analog Output is used as a step test to check the accuracy and proper operation of the
analog outputs. The test forces all four analog output channels to produce signals
ranging from 0% to 100% of the full scale range in 20% increments. This test is useful
to verify the operation of the data logging/recording devices attached to the analyzer.
(See also Section
12.5.8.2).
Access the Analog Output Step Test from the DIAG Menu as follows:
CO= XXXX
SETUP
MORE EXIT
EXIT
Performs analog output step
test 0% to 100%
SETUP X.X ENTER PASSWORD
8 1 8
DIAG SIGNAL I/O
PREV NEXT
DIAG AOUT ANALOG OUTPUT
20%
DIAG AOUT ANALOG OUTPUT
[20%]
Setup Menu
ENTR EXIT
ENTR EXIT
EXIT
EXIT
119