The Starting Date Feature; Disabling/Enabling Data Channels - Teledyne T300 Operation Manual

Data Acquisition System (DAS) and APICOM

7.1.9.2. THE STARTING DATE FEATURE

7.1.10. DISABLING/ENABLING DATA CHANNELS

Use the PREV and
NEXT bttons to scroll
to the DATA
CHANNEL to be
edited.
Toggle these buttons
to enable or disable
the CHANNEL.
184
This option allows the user to specify a starting date for any given channel in case the
user wants to start data acquisition only after a certain time and date. If the STARTING
DATE is in the past (the default condition), the DAS ignores this setting and begins
recording data as defined by the REPORT PERIOD setting.
The STARTING DATE generally cannot be accessed from the standard DAS front
panel menu, but is available via the instrument's communication ports by using
APICOM or the analyzer's standard serial data protocol.
Data channels can be temporarily disabled, which can reduce the read/write wear on the
Disk-on-Module.
To disable a data channel, follow the instruction shown in Section 7.1.4 then press:
Starting at the EDIT CHANNEL MENU
SETUP X.X 0) CONC: ATIMER 1, 800
PREV MEXT
SETUP X.X NAME: CONC
<SET SET> EDIT PRNT
Continue pressing SET> until ...
SETUP X.X CHANNEL ENABLE:ON
<SET SET> EDIT
SETUP X.X CHANNEL ENABLE:ON
ON
Teledyne API – Model T300/T300M CO Analyzer
INS DEL EDIT PRNT EXIT
EXIT
EXIT
ENTR EXIT
EXIT discards the new
setting.
ENTR accepts the
new setting.
06864B DCN6314