Configuring Bfd For Ipv4 Static Routes On The Public Network; Establishing The Configuration Task - Huawei S6700 Series Configuration Manual
Ip routing
Hide thumbs
Also See for S6700 Series:
- Configuration manual (295 pages) ,
- Hardware description (115 pages) ,
- Hardware installation and maintenance manual (183 pages)
Table of Contents
Advertisement
S6700 Series Ethernet Switches
Configuration Guide - IP Routing
Procedure
l
l
----End
1.5 Configuring BFD for IPv4 Static Routes on the Public
Network
On an IPv4 network, configuring BFD for IPv4 static routes on the public network can speed
up route convergence and improve network reliability.
1.5.1 Establishing the Configuration Task
Before configuring BFD for static routes, familiarize yourself with the applicable environment,
complete the pre-configuration tasks, and obtain the data required for the configuration. This
will help you complete the configuration task quickly and accurately.
Applicable Environment
BFD can quickly detect IPv4 forwarding failures, ensuring QoS for voice, video, and other video-
on-demand (VoD) services on an IPv4 network. With BFD, service providers can provide voice
over IP (VoIP) and other real-time services with high availability and scalability.
By binding IPv4 static routes to BFD sessions, you can use BFD sessions to provide link
detection for IPv4 static routes on the public network. A static route can be bound to a BFD
session.
Pre-configuration Tasks
Before configuring BFD for IPv4 static routes on the public network, complete the following
task:
l
Data Preparation
To configure BFD for IPv4 static routes on the public network, you need the following data.
No.
1
2
3
4
Issue 01 (2012-03-15)
Run the display ipv6 routing-table command to check brief information about the IPv6
routing table.
Run the display ipv6 routing-table verbose command to check detailed information about
the IPv6 routing table.
Configuring link layer protocol parameters and IP addresses for interfaces to ensure that
the link layer protocol status of the interfaces is Up
Data
Destination address and mask
Outbound interface or next-hop IPv4 address
IP address of the peer detected by BFD
Local discriminator and remote discriminator of a BFD session
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 IP Static Route Configuration
8
Advertisement
Table of Contents
