Multifunction Lever; Hazard Warning Switch; 2Wd/4Wd Switch - Can-Am Maverick Operator's Manual

tmo2014-006-006_b
1. Engine start button

3) Multifunction Lever

Low/High Beam Selection
When the multifunction lever is in the
middle position, the low beam is se-
lected.
Push the multifunction lever forward to
select high beam.
Pull back the multifunction lever to re-
turn to low beam.
NOTE: The ignition switch must be set
to ON with lights position to turn on the
headlights.
Headlight Flashing
To flash the high beams while in low
beams, pull on the multifunction lever.
Horn Activation
The horn can be activated by pushing
the end of the multifunction lever to-
ward the steering wheel.
Turn Signal Activation
To activate the LH turn signals, push
down the multifunction lever.
To activate the RH turn signals, push up
the multifunction lever.
Reposition the multifunction lever in
the middle position to stop turn signal.

4) Hazard Warning Switch

tmo2014-006-006_c
1. Hazard warning switch
The hazard warning switch is located
on the upper console.
When activated, all the turn signal
lights will flash.
NOTE: Hazard warning can be acti-
vated even when the ignition switch is
turned OFF.

5) 2WD/4WD Switch

The 2WD/4WD switch is located on
the upper console.
tmo2014-006-006_d
1. 2WD/4WD switch
_______________
SECONDARY CONTROLS
41