Configuring Minimum Unicast Bandwidth - Cisco ASR 9000 Series Configuration Manual

Configuring Subscriber Features
To define the bandwidth profile, see
To specify the mode for Multicast HQoS, see
Mode, on page

Configuring Minimum Unicast Bandwidth

A minimum unicast bandwidth can be configured, to prevent unicast traffic from being completely cut off by
oversubscribed multicast traffic. Perform this task to set the guaranteed minimum unicast bandwidth for a
subscriber using QoS.
SUMMARY STEPS
1. configure
2. dynamic-template
3. type [ppp|ip-subscriber|service]name
4. qos output minimum-bandwidth range
5. exit
6. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RSP0/CPU0:router# configure
Step 2 dynamic-template
Example:
RP/0/RSP0/CPU0:router(config)# dynamic-template
Step 3 type [ppp|ip-subscriber|service]name
Example:
RP/0/RSP0/CPU0:router(config-dynamic-template)# type ppp
p1
Step 4 qos output minimum-bandwidth range
Example:
RP/0/RSP0/CPU0:router(config-dynamic-template-type)# qos
output minimum-bandwidth 10
OL-26148-02
144.
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Configuration Guide, Release
Configuring Minimum Unicast Bandwidth, on page
Configuring Multicast HQOS Correlation Mode or Passive
Purpose
Enters global configuration mode.
Enters dynamic template configuration mode.
.
Specifies the type of dynamic template that needs
to be applied. Three available types are:
• PPP
• IP-subscriber
• Service
Sets the guaranteed minimum bandwidth, in kbps,
for a subscriber. Range is from 1 to 4294967295.
HQoS Correlation
143.
4.2.x
143