Application; Quality Of Service (Qos) - Cisco SPA232D Administration Manual

Configuring the Network

Application

Application
Cisco SPA232D Administration Guide
Use the Network Setup > Application pages to support voice service and any
servers that you host for public access.
•

Quality of Service (QoS)

• Port Forwarding
• DMZ
Quality of Service (QoS)
Use the Network Setup > Application > QoS page to set the upstream bandwidth
to suit your broadband service. This feature is enabled by default and helps to
ensure that voice is prioritized during periods of heavy network traffic.
To open this page: Click Network Setup in the menu bar, and then click
Application > QoS in the navigation tree.
Enter the settings as described below. After making changes, click Submit to save
your settings, or click Cancel to redisplay the page with the saved settings.
Field
QoS Policy
Upstream
Bandwidth
Description
Click Always On to enable QoS settings at all times, or
click On When Phone In Use to enable it only when
there is voice traffic.
Default setting: On When Phone In Use
Enter the maximum available upstream bandwidth value
specified by your Internet Service Provider.
Default setting: 10000 kbps
IMPORTANT: Do not overstate the upstream bandwidth
that you receive from your service provider. Setting this
value higher than the available service bandwidth can
result in traffic being dropped arbitrarily in the service
provider's network.
3
44