Siemens SIMOVERT MASTERDRIVES Manual page 1389

Connector number
K0807
K0808
K0809
KK0810
KK0811
Siemens AG 6SE7087-6QX70 (Edition AG)
SIMOVERT MASTERDRIVES
Connector name Description
Scale X Denomin Fixed connector for denominator
scaling x-axis U623.2
in function diagram: 839.1
Scale Y Numer Fixed scaling, Y-axis table,
denominator
in function diagram: 839.6
Scale Y Denomin Fixed scaling, Y-axis table,
denominator
in function diagram: 839.6
Status_Table1 Bit 0 to 15: Number of support values
(up to last fault-free support value)
Bit 16 to 23: Fault code
Bit 24: Table reset running
Bit 25: Table transfer running
Bit 26 to Bit 29: Spare
Bit 30: Group fault
Bit 31: Transfer finished and fault-free
Fault code
0: No fault
1: Number of support values = 0 or
higher maximum number of support
points
2: Position value of master axis higher
than table width
3: Position value of master axis not
rising
4: Data block not present (M7)
5: Data block too short (M7)
Last correct support point number in
the event that an error has occurred
during transfer to the table. The next
support point is therefore the faulty
support point.
See fault code.
In function diagram: 839.2
Status_Table2 Bit 0 to 15: Number of support values
(up to last fault-free support value)
Bit 16 to 23: Fault code
Bit 24: Table reset running
Bit 25: Table transfer running
Bit 26 to Bit 29: Spare
Bit 30: Group fault
Bit 31: Transfer finished and fault-free
Fault code
0: No fault
1: Number of support values = 0 or
higher maximum number of support
points
2: Position value of master axis higher
than table width
3: Position value of master axis not
rising
4: Data block not present (M7)
5: Data block too short (M7)
Last correct support point number in
the event that an error has occurred
during transfer to the table. The next
support point is therefore the faulty
support point.
See fault code.
In function diagram: 839.2
Compendium Motion Control
DSP Double word
no no
no no
no no
no yes
no yes
19