Siemens SIMOVERT MASTERDRIVES Manual page 1404

Binector number
B0141
B0142
B0143
B0144
B0145
B0146
B0147
B0148
B0149
B0150
B0151
B0152
B0153
B0156
B0157
B0158
B0159
B0162
B0163
B0170 ... B0185
B0200
B0201
B0202
B0203
B0204
B0205
B0210
B0211
B0212
B0215
B0216
B0217
B0220
Siemens AG 6SE7087-6QX70 (Edition AG)
SIMOVERT MASTERDRIVES
Binector name
No Ext Fault 2
Ext Warning
No Ext Warning
Ovld Warn Drive
No OvldWarn Drv
Tmp Flt Drive
No Tmp Flt Drv
TmpWarn Drive
No TmpWarn Drv
TmpWarnMotor
No TmpWarnMotor
TmpFltMotor
No TmpFltMotor
Motor PullOut
No MotorPullOut
ChrgRelay close
ChrgRelay open
Prechrg active
Prechrg n.act.
C->B CONV4
No SpdDir Sel
Accel active
Decel active
Limitr FWD act.
Limitr REV act.
RelPosContrByps
RefPoint sensed
Pos Corrected
PosMem Valid
MaEnAcknRef
AckPosCorMEncod
AckMVal MEncod
PosReg release
Compendium Motion Control
Description
"NO external fault 2" binector
"External alarm" binector
"NO external alarm" binector
"Converter overload alarm" binector
"NO converter overload alarm" binector
"Converter overtemperature fault active" binector
"NO converter overtemperature fault active" binector
"Converter overtemperature alarm active" binector
"NO converter overtemperature alarm active" binector
"Motor overtemperature alarm active" binector
"NO motor overtemperature alarm active" binector
"Motor overtemperature fault active" binector
"NO motor overtemperature fault active" binector
"Motor pulled out" binector
"Motor NOT pulled out" binector
"Bypass contactor energized" binector
"Bypass contactor NOT energized" binector
"Precharging active" binector
"Precharging NOT active" binector
16 binectors of the 4th connector -> binector converter
No direction of rotation selected
Acceleration active
Deceleration active
Speed limitation positive rotation direction reached
Speed limitation negative rotation direction reached
The binector indicates that the ramp-function
generator bypass for the position controller is
available.
Checkback of position sensor: Reference point
detected
Status bit of position sensor: Position corrected
The binector indicates that a valid value has been
registered by the measured-value memory.
Position sensing binector external encoder
acknowledgement "Reference point detected"
In function diagram 335.7
Position sensing binector external encoder
acknowledgement "Position corrected"
In function diagram 335.7
Position sensing binector external encoder
acknowledgement "Measured value valid"
In function diagram 335.7
Status bit of position control released
4