Mounting The Ptx1000 In A Rack; Before You Begin Mounting The Ptx1000 - Juniper PTX1000 Hardware Manual

PTX1000 Packet Transport Router Hardware Guide
Table 30: Inventory of Components Supplied with a PTX1000 (continued)
Component
Front-mounting rails
RJ-45 cable and RJ-45 to DB-9 adapter

Mounting the PTX1000 in a Rack

68
You can mount a PTX1000 in a four post 19-in. rack by using the included mounting
brackets.
For four-post rack installation, the shipping carton contains two front-mounting rails
with two matching rear-mounting blades. This configuration allows either end of the
PTX1000 to be mounted flush with the rack and still be adjustable for racks with different
depths. The minimum distance the front and rear rack rails can be spaced apart is 28 in.
(71.1 cm) front to back. The maximum distance the front and rear rack rails can be spaced
apart is 36 in. (91.4 cm) front to back.
Before You Begin Mounting the PTX1000 on page 68
Mounting the PTX1000 on page 69

Before You Begin Mounting the PTX1000

Before you begin mounting a PTX1000 in the rack:
Ensure that you understand how to prevent electrostatic discharge (ESD) damage.
1.
See "Prevention of Electrostatic Discharge Damage" on page
Verify that the site meets the requirements described in
2.
Checklist" on page 45.
Place the rack in its permanent location, allowing adequate clearance for airflow and
3.
maintenance, and secure it to the building structure.
Read "General Safety Guidelines and Warnings" on page 112
4.
Safety Guidelines" on page
page 118.
Remove the PTX1000 from the shipping carton (see
5.
page 67).
Ensure that you have the following parts and tools available to mount the PTX1000
6.
in a rack:
Either a mechanical lift or two persons to lift the PTX1000 into place. An additional
person is needed for securing the router to the rack.
ESD grounding strap (not provided).
66, and "Chassis and Component Lifting Guidelines" on
"Unpacking the PTX1000" on
Copyright © 2018, Juniper Networks, Inc.
Quantity
2
1
135.
"PTX1000 Site Preparation
, "PTX1000 Installation