Trigger:lan<N>:In:clear; Trigger:lan<N>:In:edge - Keithley 2461 Reference Manual

Section 6: SCPI command reference
:TRIGger:LAN<n>:IN:CLEar
This command clears the event detector for a LAN trigger.
Type
Command only
Usage
:TRIGger:LAN<n>:IN:CLEar
<n>
Details
The trigger event detector enters the detected state when an event is detected. This function clears a
trigger event detector and discards the previous of the trigger packet.
This function clears all overruns associated with this LAN trigger.
Example
:TRIG:LAN5:IN:CLE
Also see
:TRIGger:LAN<n>:IN:OVERrun?
:TRIGger:LAN<n>:IN:EDGE
This command sets the trigger operation and detection mode of the specified LAN event.
Type
Command and query
Usage
:TRIGger:LAN<n>:IN:EDGE <mode>
:TRIGger:LAN<n>:IN:EDGE?
<n>
<mode>
Details
This command controls how the trigger event detector and the output trigger generator operate on the
given trigger. These settings are intended to provide behavior similar to the digital I/O triggers.
LAN trigger mode values
Mode
EITHer
FALLing
RISing
6-216
Affected by
Not applicable
The LAN event number (1 to 8) to clear
(on page 6-217)
Affected by
Recall settings
Instrument reset
Power cycle
The LAN event number (1 to 8)
The trigger mode; see the Details for more information
Trigger packets detected as input
Rising or falling edge (positive or negative state)
Falling edge (negative state)
Rising edge (positive state)
Model 2461 Interactive SourceMeter® Instrument Reference Manual
Where saved
Not applicable
Clears the event detector with LAN packet 5.
Where saved
Save settings
LAN trigger packet generated for
output with a...
negative state
negative state
positive state
Default value
Not applicable
Default value
EITH
2461-901-01 A/November 2015