Trigger:block:notify - Keithley 2461 Reference Manual

Section 6: SCPI command reference

:TRIGger:BLOCk:NOTify

This command defines a trigger model block that generates a trigger event and immediately continues to the next
block.
Type
Command only
Usage
:TRIGger:BLOCk:NOTify <blockNumber>, <notifyID>
<blockNumber>
<notifyID>
Details
When trigger model execution reaches a notify block, the instrument generates a trigger event and
immediately continues to the next block.
Other commands can reference the event that the notify block generates. This assigns a stimulus
somewhere else in the system. For example, you can use the notify event as the stimulus of a
hardware trigger line, such as a digital I/O line.
When you call this event, you use the format NOTIFY followed by the notify identification number. For
example, if you assign <notifyID> as 4, you would refer to it as NOTIFY4 in the command that
references it.
Example
:TRIG:BLOC:NOT 5, 2
:TRIG:BLOC:BRAN:EVEN 6, NOTIFY2, 2
Also see
Notify block (on page 3-112)
6-206
Model 2461 Interactive SourceMeter® Instrument Reference Manual
Affected by
Recall settings
Instrument reset
Power cycle
The sequence of the block in the trigger model
The identification number of the notification; 1 to 8
Where saved
Save settings
Define trigger model block 5 to be the notify 2
event. Assign the notify 2 event to be the trigger
for stimulus for the branch event for block 6.
Default value
Not applicable
2461-901-01 A/November 2015