Trigger:blender<N>:Overrun; Trigger:blender<N>:Stimulus<M - Keithley 2461 Reference Manual

Section 6: SCPI command reference
:TRIGger:BLENder<n>:OVERrun?
This command indicates whether or not an event was ignored because of the event detector state.
Type
Query only
Usage
:TRIGger:BLENder<n>:OVERrun?
<n>
Details
Indicates if an event was ignored because the event detector was already in the detected state when
the event occurred. This is an indication of the state of the event detector that is built into the event
blender itself.
This command does not indicate if an overrun occurred in any other part of the trigger model or in any
other trigger object that is monitoring the event. It also is not an indication of an action overrun.
Example
:TRIG:BLEN1:OVER?
Also see
:TRIGger:BLENder<n>:CLEar
:TRIGger:BLENder<n>:STIMulus<m>
This command specifies the events that trigger the blender.
Type
Command and query
Usage
:TRIGger:BLENder<n>:STIMulus<m> <event>
:TRIGger:BLENder<n>:STIMulus<m>?
<n>
<m>
<event>
6-184
Model 2461 Interactive SourceMeter® Instrument Reference Manual
Affected by
Not applicable
The blender number (1 or 2)
(on page 6-182)
Affected by
Recall settings
Instrument reset
Power cycle
Trigger blender clear
The blender number (1 or 2)
The stimulus input number (1 to 4)
See Details
Where saved
Not applicable
If an event was ignored, the output is 1.
If an event was not ignored, the output is 0.
Where saved
Save settings
Default value
Not applicable
Default value
NONE
2461-901-01 A/November 2015