Trigger:lan<N>:In:overrun - Keithley 2461 Reference Manual

Model 2461 Interactive SourceMeter® Instrument Reference Manual
Example
:TRIG:LAN2:IN:EDGE FALL
Also see
Digital I/O
TSP-Link System Expansion Interface
:TRIGger:LAN<n>:IN:OVERrun?
This command indicates the overrun status of the LAN event detector.
Type
Query only
Usage
:TRIGger:LAN<n>:IN:OVERrun?
<n>
Details
This command indicates whether an event has been ignored because the event detector was already
in the detected state when the event occurred.
This is an indication of the state of the event detector built into the synchronization line itself. It does
not indicate if an overrun occurred in any other part of the trigger model, or in any other construct that
is monitoring the event.
It also is not an indication of an output trigger overrun.
The trigger overrun state for the specified LAN packet is returned as 1 (true) or 0 (false).
Example
TRIG:LAN5:IN:OVER?
Also see
:TRIGger:LAN<n>:IN:CLEar
2461-901-01 A/November 2015
(on page 3-86)
Affected by
TRIGger:LAN<n>:IN:CLEar
The LAN event number (1 to 8)
(on page 6-216)
Set the LAN trigger mode for event 2 to falling.
(on page 3-150)
Where saved
Not applicable
Checks the overrun status of a trigger on LAN5
and outputs the value, such as:
0
Section 6: SCPI command reference
Default value
Not applicable
6-217