[:Sense[1]]:<Function>:Average[:State] - Keithley 2461 Reference Manual

Model 2461 Interactive SourceMeter® Instrument Reference Manual
[:SENSe[1]]:<function>:AVERage[:STATe]
This command enables or disables the averaging filter for measurements of the selected function.
Type
Command and query
Usage
[:SENSe[1]]:<function>:AVERage[:STATe] <state>
[:SENSe[1]]:<function>:AVERage[:STATe]?
<function>
<state>
Details
This command enables or disables the averaging filter. When this is enabled, the reading returned by
the instrument is an averaged value, taken from multiple measurements. The settings of the filter
count and filter type for the selected measure function determines how the reading is averaged.
If you send this command without the <function> parameter, it sets the state of the averaging filter
for all functions.
Example 1
CURR:AVER:COUNT 10
CURR:AVER:TCON MOV
CURR:AVER ON
Example 2
RES:AVER:COUNT 10
RES:AVER:TCON MOV
RES:AVER ON
Example 3
VOLT:AVER:COUNT 10
VOLT:AVER:TCON MOV
VOLT:AVER ON
Also see
Filtering measurement data
[:SENSe[1]]:<function>:AVERage:COUNt
[:SENSe[1]]:<function>:AVERage:TCONtrol
2461-901-01 A/November 2015
Affected by
Recall settings
Instrument reset
Power cycle
Measure configuration list
The measure function:
Current: CURRent[:DC]
•
Resistance: RESistance
•
Voltage: VOLTage[:DC]
•
The filter status; set to one of the following values:
Disable the averaging filter: OFF or 0
•
Enable the averaging filter: ON or 1
•
(on page 4-23)
(on page 6-53)
(on page 6-56)
Section 6: SCPI command reference
Where saved
Save settings
Measure configuration list
Set the averaging filter type to moving
average, with a filter count of 10.
Enable the averaging filter.
Set the averaging filter type to moving
average, with a filter count of 10.
Enable the averaging filter.
Set the averaging filter type to moving
average, with a filter count of 10.
Enable the averaging filter.
Default value
OFF (0)
6-55